Coloronix Color Ray Dokumentacja Pobierz pdf (Strona 8)

Electrical Connection

NOTE: Supply lead wires should not be connected to a dimmer of any sort.

Installing Your Color Ray Receiver

1. Prepare Wires:

Note: Make sure the low-voltage wiring is installed at the wall box that

will house the Color Ray receiver.

• Be sure that the ends of the wires from the wall box are

straight—cut if necessary.

• Remove 5/8” or 1.6 cm of insulation from each wire in the wall

box.

2. Connect CAT5/RJ45 Cable to Receiver Coupler

3. Connect Power

Connect the line voltage (120V) wires in the following manner:

Screw the wire nuts clockwise so that no bare conductors show

below the wire connectors. Secure each connector with the

electrical tape.

• Green dimmer Ground lead to Green or bare copper wire in

wall box.

4. Test the Color Ray Receiver prior to mounting in wall box:

• Restore the power at the circuit breaker or fuse.

• Turn remote on to test.

• If the lights still do not turn on, refer to the troubleshooting section.

Page 8—Coloronix Color Ray Manual V1.0

1 2 3 4 5 6 7 8 9 10 11

Brak uwag

Coloronix Color Ray Dokumentacja Strona 8